fbpx
Connect with us

Education

Cylinder Head Oil Leak or Weepage Found on Some 4.6L and 5.4L Engines

Advertisement

Some vehicles equipped with the Romeo 4.6L 2V engine or 5.4L 2V Windsor and 5.4L Supercharged engine may exhibit an oil leak or oil weepage from the cylinder head gasket at the right-hand rear or the left-hand front of the engine. Oil weepage is not considered detrimental to engine performance or durability. An oil leak may be caused by metal chip debris lodged between the head gasket and the block, chip debris between the cylinder head and the head gasket, or by damage to the cylinder head sealing surface that occurred during the manufacturing process.

Advertisement

Once an oil leak is verified with a black light test at the head gasket joint, replacement of the head gasket can be performed. If the head was damaged by chip contamination, the head should be replaced. A revised “service-only” gasket is now released for both of these cases.
 
Required for service are:

• A straightedge (machine flatness toleranced to 0.0002” per foot in length) that’s available from local tool dealers or as provided by Ford Motor Co.;
• Motorcraft Silicone Gasket Remover (ZC-30);
• Metal Surface Prep (ZC-31); and
• Service-only gasket (3U7Z-6051-BA for driver’s side and/or 3U7Z-6051-AA for passenger’s side) with the new embossed area.
 
Repair Procedure
Cylinder heads damaged by brinnelling (depression marks from original gasket) of the head may still be reusable. The revised “service-only” gasket has a feature by which the embossed sealing area does not follow the same sealing path as the original gasket. This area is surrounding the High Pressure Oil Feed (HPOF) area. It’s triangular in shape and is found in the rear of the passenger’s side cylinder head, or in the front of the driver’s side cylinder head.

Advertisement

If performing in vehicle service, the engine should be allowed to cool before removing the head or warpage may occur in deck flatness. The cylinder head and block decks should be cleaned before performing a flatness check. Dark metal stains below the surface of the metal are normal. Do not attempt to polish off the stains with grinders or scrapers. Use a plastic scraper (or plastic ice scraper or equivalent) to pull away any residual silicone RTV with ZC-30 and ZC-31 applied in sequence.

Cylinder head kits are available on most applications from Ford and include complete head assembly, with cam and valves; head bolts, service-only head gasket; both intake gaskets exhaust gasket; one rocker cover gasket; and one set of exhaust studs and nuts.

Advertisement

If it’s found that only one head is leaking, it’s not necessary to remove the other head. Repair only the side for which leakage occurs.
 
ALLDATA Technical Editor Eric Seifert is an ASE-certified Master Technician and Engine Machinist, with 20 years of independent shop and parts store experience.
 
— Technical service bulletin courtesy of ALLDATA.

Advertisement
Click to comment

POPULAR POSTS

Sponsored Content

Protecting Your Vehicle in the Winter

Sponsored Content

A Closer Look: Standard® Gasoline Direct Injection (GDI)

Connect
Counterman Magazine